Table of Contents
Advertisement
Initial Configuration
The following components are recommended for a typical development system. Note that this is a
recommended configuration only.
Note
You may substitute other components for the ones listed below, such as a PS/2
mouse and keyboard, a parallel ATA hard drive or CD-ROM drive, or another type
of monitor. If you substitute other components, be sure to adjust the basic setup
steps accordingly.
EBX-22 single board computer
240-pin SODIMM (memory module): DDR2-400 or DDR2-533
ATX power supply with motherboard and drive connectors
SVGA video monitor
USB keyboard and mouse
SATA hard drive
USB CD-ROM drive
The following VersaLogic cables are recommended.
Video adapter cable (CBR-1201)
SATA data cable (CBR-0701)
ATX to SATA power adapter cable (CBR-0401)
Power adapter cable (CBR-2022)
You will also need a Windows (or other OS) installation CD.
Basic Setup
The following steps outline the procedure for setting up a typical development system. The EBX-
22 should be handled at an ESD workstation or while wearing a grounded antistatic wrist strap.
Before you begin, unpack the EBX-22 and accessories. Verify that you received all the items you
ordered. Inspect the system visually for any damage that may have occurred in shipping. Contact
Support@VersaLogic.com immediately if any items are damaged or missing.
Gather all the peripheral devices you plan to attach to the EBX-22 and their interface and power
cables.
It is recommended that you attach standoffs to the board (see Hardware Assembly) to stabilize the
board and make it easier to work with.
Figure 3 shows a typical start-up configuration.
EBX-22 Reference Manual
Configuration and Setup
2
8
Advertisement
Table of Contents
