Operating System Installation; Bios Setup - VersaLogic Hawk Reference Manual

3. Review Configuration

Before you power up the system, double-check all the connections. Make sure all cables
are oriented correctly, that adequate power will be supplied to the Hawk, and all attached
peripheral devices.
4. Power On

Turn on the ATX power supply and the video monitor. If the system is correctly
configured, a video signal should be present.
5. Install Operating System

Install the operating system according to the instructions provided by the operating
system manufacturer.

Operating System Installation

The standard PC architecture used on the Hawk makes the installation and use of most of the
standard x86-based operating systems very simple. The operating systems listed on the
VersaLogic Software Support
maker of the operating system. Special optimized hardware drivers for a particular operating
system, or a link to the drivers, are available on the

BIOS Setup

Refer to the VersaLogic System Utility Reference Manual
the Hawk BIOS.
VL-EPU-3310 Reference Manual
page use the standard installation procedures provided by the
Hawk Support
Configuration and Setup
Page.
for information on how to configure
9