RADION receiver SD
You will need approximately 254 mm (10 in) of clearance on one
side of the base to provide easy access to the opening
mechanism, and approximately 15 mm (0.6 in) of clearance on
the opposite side to compensate for the physical dimensions of
the device cover. This should allow for adequate space in which
the device cover can be opened, and the cover removed.
Other mounting considerations include;
–
–
3.4.3
Wiring considerations
Notice!
Do not install long cable runs next to high-current power feeds.
Keep cable lengths as short as possible to minimize noise
pickup.
Ensure that the wiring used meets the following specifications:
–
–
Bosch Security Systems B.V.
Minimum clearance above the location to compensate for
the vertical sliding movement to attach or remove the
device from the base is: >30 mm (1.2 in).
Minimum clearance below the location where the base is
mounted: >23 mm (0.9 in).
Four-conductor unshielded 0.65 mm (22 AWG) to 2.0 mm
(18 AWG) maximum.
Wire length must not exceed 243 m (800 ft) from the
control panel
RADION receiver SD | en
2020.05 | 13 | F.01U.261.834
25