Bosch RADION B810 Installation Manual page 36

36 en | RADION receiver SD
LED condition
On (Normal)
Off
Continuous
Flash: 1 sec On,
1 sec Off
Turns Off
momentarily
Continuous
Flash: A 3-pulse
signal, followed
by a short delay
at the end of the
rd
3 pulse
(Communication
error)
Continuous
Flash: A
continuous pulse
between On and
Off states
(Trouble state)
Flash 3 times:
2020.05 | 13 | F.01U.261.834
Pattern description
Indicates the receiver is functioning
normally.
Indicates there is a power failure to the
receiver, or that the receiver is not wired
correctly.
Indicates the receiver is being programmed
with the zone and transmitter ID's from the
compatible control panel.
Indicates the receiver obtained a valid
transmission from a RADION transmitter.
Indicates the receiver has experienced a
communication error and/or a self-test
failure. This error could be a result of either:
– A communication failure between the
control panel and receiver, or
– An invalid address switch setting.
– Indicates the receiver is in a trouble
state, experiencing a radio frequency
interference failure.
– A communication failure with internal
hardware components within the
receiver
Indicates the receiver has obtained a new
radio frequency ID while in "Learn Mode".
RADION receiver SD
Bosch Security Systems B.V.