Bosch RADION B810 Installation Manual page 27

RADION receiver SD
The first step to enable communication is to verify that the
RADION transmitter is programmed into the control panel. This
is achieved by configuring a point source index as wireless.
RFID programming from a supported keypad is achieved by:
–
–
The preferred method of entering in the RFID number would be
to enter it in manually through the keypad - point source/RFID,
or RPS. Doing so gives you greater control and security, while
reducing the risk of incomplete RFID programming.
The workflow listed below is a generic representation of the
programming/enablement process. Refer to the Points Menu
Parameters section inside the Keypad Installer Menu chapter of
the compatible Bosch control panel Installation and System
Reference Guides, or Points - Point Assignments in RPS Help
File for more information.
Point source/RFID programming
A point's source gives a description as to the physical location
of the point for installation and service personnel:
1.
2.
3.
4.
5.
6.
7.
8.
The control panel is enabled to receive wireless communication
information from the RADION transmitter.
Bosch Security Systems B.V.
Through the point source/RFID menu options, or
Enroll point RFID for wireless points - which uses the "Auto-
Learn" methodology.
Using either RPS, or a supported keypad, access the
Program Menu, and select the Points menu option.
Select the Source menu.
Select the point source of the device you are programming.
Change the point source to the "wireless."
Save changes.
Select the RFID menu to edit the RFID of each RADION
device.
Enter in the unique RFID as it appears on the RFID sticker
in the illustration below. ID's beginning with a zero may not
display in the keypad UI, or RPS
Save changes and exit the menu.
RADION receiver SD | en
2020.05 | 13 | F.01U.261.834
27