Base Mounting Installation; Wiring Considerations - Bosch Radion B810 Reference Manual

RADION receiver SD
3.3.2

Base mounting installation

Some consideration and planning are required when locating a position to mount the base of
the receiver onto the desired surface. The base must be mounted in such a way that provides
plenty of accessible space to insert a flat-headed screwdriver, and remove the receiver cover
when maintenance and troubleshooting scenarios occur.
Because of the location of the opening mechanism on the side of the device, you will need
approximately 254 mm (10 in) of clearance on one side of the base to provide easy access to
the opening mechanism, and approximately 15 mm (0.6 in) of clearance on the opposite side
to compensate for the physical dimensions of the device cover. This should allow for adequate
space in which the device cover can be opened, and the cover removed, should the need
arise.
Other mounting considerations include;
–
–
3.3.3

Wiring considerations

Notice!
Do not install long cable runs next to high-current power feeds. Keep cable lengths as short
as possible to minimize noise pickup.
Ensure that the wiring used meets the following specifications:
–
–
Bosch Security Systems, Inc.
Minimum clearance above the location to compensate for the vertical sliding movement
to attach or remove the device from the base is: >30 mm (1.2 in).
Minimum clearance below the location where the base is mounted: >23 mm (0.9 in).
Four-conductor unshielded 0.65 mm (22 AWG) to 2.0 mm (18 AWG) maximum.
Wire length must not exceed 243 m (800 ft) from the control panel
Reference Guide
RADION receiver SD | en
2014.03 | 06 | F.01U.261.834
15