Bosch RADION B810 Installation Manual page 32

32 en | RADION receiver SD
noisy room they would not be able to hear each other as clearly
and the "signal margin" would be much lower. When the signal
margin is low enough conversation is no longer possible.
The RADION receiver monitors the signal level of every system
transmitter and report an interference trouble (sometimes
called Jamming) if the signal margin of a transmitter is reduced
to the point where communications might be lost.
To ensure reliable system communications, the signal level and
margin of every transmitter, including repeaters, should be
tested and verified to be reporting "good" at the time of
installation and in the unlikely event of a interference trouble
report.
Signal strength test (for Points and Receiver)
Use the following procedure to test the frequency strength and
range of the RADION system.
1.
2.
3.
4.
Signal strength test (for Repeaters)
1.
2.
3.
4.
2020.05 | 13 | F.01U.261.834
From the keypad, access the Wireless Menu, and select
Diagnostics.
Select RF Points.
Select Signal menu and choose the desired option. Various
sub-categories display including:
– Signal strength
– Level
– Margin
Exit the menu.
From the keypad, access Wireless Menu, and select
Diagnostics.
Select RF Repeaters.
Select the Signal menu and choose the repeater. Various
sub-categories display including:
– Signal strength
– Level
– Margin
Exit the menu.
RADION receiver SD
Bosch Security Systems B.V.