Walk Test (For Motion Detectors) - Bosch RADION B810 Installation Manual

30 en | RADION receiver SD
2.
3.
4.
5.
6.
3.4.6

Walk test (for motion detectors)

Use the following pattern testing procedure to test the detector
range and functionality.
Notice!
Also see Control Panels (D9412GV4/D7412GV4) SIA CP-01
Quick Reference Guide P/N: F.01U.265.466, and/or (B6512/
B5512/B4512) SIA CP-01 Quick Reference Guide P/N:
F.01U.265.464).
Motion walk test
Remove and replace cover to activate a 90-sec Walk Test Mode.
During this Test Mode, any activity in the sensor's coverage
pattern will cause a transmitted alarm and LED activation. Each
alarm will also extend the Test Mode for an additional 90-sec.
Walk Testing should be done across the coverage pattern. The
edge of the coverage pattern is determined by the first flash of
the LED. This may change slightly depending upon the sensitivity
setting. Walk Test the unit from both directions to determine the
pattern boundaries. Although generally not required, if masking
is desired, the lens diagram shows the appropriate areas to be
masked. Use an opaque material (such as, electrical tape) to
mask the desired areas.
2020.05 | 13 | F.01U.261.834
Select the option for enrolling a point RFID.
When asked, select the point source you are enrolling).
Initiate activity for the desired device (walk through the
coverage pattern if enrolling a motion detector, or press the
button on the keyfob if enrolling a keyfob, open the door or
window if enrolling a contact). By doing so, the control
panel recognizes the first RFID it comes in contact with.
When the keypad or RPS shows Point Enrolled, exit out of
the application.
Verify the RFID displayed on the keypad matches the RFID
sticker that appears on the activated device.
RADION receiver SD
Bosch Security Systems B.V.