Bosch RADION B810 Installation Manual page 49

RADION receiver SD
1.
2.
3.
Performing the alarm test with Sentrol 5709C hand-held tester:
1.
Notice!
If blinds or drapes are present, test the area by holding the
hand-held tester behind the closed blinds or drapes.
2.
Bosch Security Systems B.V.
Set the tester for tempered or laminated glass, unless the
protected glass is plate glass.
Hold the tester on top of the detector.
Activate the tester. The detector alarms and goes into test
mode for one minute. During test mode, the LED blinks
continuously. To extend test time, activate the tester within
the range of the sensor at least once each minute.
Hold the tester near the surface of the glass to be
protected and aim the speaker at the sensor. Be sure the
tester is at the point on the glass farthest from the
detector.
Press the test button on the tester. The LED on the
detector stays on for 4 seconds to indicate the glass is
within detection range of the sensor. If the LED does not
stay in a solid state momentarily, but continues to blink,
adjust the positioning of the detector so that it is closer to
the window, and re-test. Check the battery strength of the
hand-held testing device before the test.
RADION glassbreak | en
2020.05 | 13 | F.01U.261.834
49