Porsche Taycan Owner's Manual page 46

Adaptive Cruise Control (ACC)
Vehicles with large projecting loads
A
B
C
D
E
F
G
H Fig. 11: Vehicles with large projecting loads
In the case of vehicles ahead with long projecting
I
loads (e.g. a lumber truck), the end of the vehicle
J
may not be detected or may not be detected cor-
rectly by the radar sensor.
K
L Responding to warning symbols
Always observe any warning and information mes-
M
sages displayed in the vehicle.
> Please see chapter "Warning and information
N
messages" on page 244.
O
Operating principle
P
Q
Adaptive Cruise Control (ACC) automatically main-
tains a set speed and a set distance at a speed of
R
approx. 19 mph - 130 mph (30 km/h - 210 km/h)
without having to use the accelerator pedal.
S
If another vehicle that is traveling slower than the
T
selected speed is detected ahead in the same lane,
ACC automatically maintains a set distance. Adap-
U
tive Cruise Control will cause the vehicle to brake if
V
the distance from the vehicle in front becomes too
short and accelerate if the distance increases.
W
If the vehicle in front stops, ACC brakes the vehicle
X
to a stop and then accelerates again automatically if
the vehicle in front starts driving again within 15
Y
seconds. Otherwise, automatic speed and distance
Z
control can be resumed.
44
The speed of the vehicle can be increased at any
time by pressing the accelerator pedal. The stored
desired speed and distance settings are retained and
are set again after the accelerator pedal is released.
The speed of the vehicle can be decreased at any
time by braking. This switches the system to passive
mode.
Controls
Fig. 12: Control lever for driver assistance systems
R Switch systems on/off and open options menu
S Open options menu (when system is switched on)
1 Set/increase the desired speed
2 Reduce the desired speed
3 RESUME: Resume control, adopt speed
4 CANCEL: Interrupt control
Display elements
Fig. 13: Adaptive cruise control
A Own speed
B Set desired speed
C Speed of the vehicle ahead
D Vehicle detected ahead
E Desired distance from the vehicle ahead
F Status display and desired speed
Status display symbols
Symbol Meaning
ACC is passive.
ACC is passive at the set desired
speed.