Porsche Taycan Owner's Manual page 42

Active Parking Support
A
Tap the corresponding icon on the central
display.
B
on the center console operating panel pul-
C
sates blue.
D
4. Tap on the center console operating panel.
E
5. Release the brake pedal.
F
The pulling-out procedure starts.
6. Observe the information on the central display.
G
To cancel the parking procedure:
> Please see chapter "Aborting the parking
H
procedure" on page 40.
I
A message appears when the vehicle reaches the
J
target position.
The vehicle drives out of the parking space until a
K
collision-free exit is possible.
L
7. Assume control of the vehicle.
M
Aborting the parking procedure
N
To interrupt parking briefly:
O
e Tap
on the center console operating panel.
P
– or –
Q
e Bring the vehicle to a stop by pressing the brake
pedal.
R
The parking procedure can then be continued:
S
b b Brake pedal released.
T
1. Press the brake pedal again and hold.
U
2. Tap on the center console operating panel.
V
3. Release the brake pedal.
The parking procedure is continued.
W
X
Y
Z
40
The following actions end the parking procedure:
e Intervening in the steering.
– or –
e Changing transmission range.
– or –
e Applying the parking brake.
– or –
e Opening a door.
– or –
e Press the accelerator.
The parking procedure must be restarted. To do this,
switch operational readiness off and back on again
when pulling out.
Maneuvering Assist
General safety instructions
Lack of attention
WARNING
The system must not induce you to take risks with
your safety. The driver is always responsible for tak-
ing due care. The system is no substitute for the
driver's attentiveness.
e Always check the traffic situation and the area
around the vehicle.
e If necessary, assume control and brake the ve-
hicle yourself.
e Observe the safety instructions and system lim-
its of the supporting systems, sensors and
cameras.
Information on further assistance systems:
> Please see chapter "Active Parking Support" on
page 38.
> Please see chapter "ParkAssist" on page 164.
System limitations
– The system is not available if a bicycle rack is
mounted on the rear.
– In order for the system to detect obstacles in the
driving path, they must be higher than approx.
4 in. (10 cm) and be stationary.
– The system is not available while active parking
support is in use.
Scope of functions
Maneuvering Assist uses sensors to monitor the area
behind and to the sides of the vehicle. If static ob-
stacles are detected, the system will brake the ve-
hicle to a standstill.
The system is available subject to the following
prerequisites:
– Transmission range R is selected.
– The symbol on the screen is active.
– The vehicle speed is max. 5 mph (10 km/h).
Following braking by Maneuvering Assist:
e Take control of the vehicle by pressing the brake
or accelerator pedal.
Maneuvering Assist is temporarily deactivated,
but remains switched on.
Switching Maneuvering Assist on and off
e e Assist e
Maneuvering Assist is switched on or off.
Switching Maneuvering Assist off temporarily
e Tap the
button in the rear view camera's
touch display.
The button in the rear view camera's touch dis-
play lights up blue. Maneuvering Assist is switched
off for the current maneuvering situation.