Porsche Taycan Owner's Manual page 264

Wheels and Tires
Changing wheels
A
B
Preparing the vehicle
C
WARNING
D
E
A vehicle on which the leveling system is activated
can move unexpectedly or tip or fall off lifting
F
equipment, e.g. a jack or lifting platform. This can
G
cause serious injuries and damage.
e Manually set Normal level and switch off the
H
leveling system before raising the vehicle.
I
e e Settings e Vehicle e Additional
J
chassis settings e Deactivate chassis
K
adjustments to use a jack
L
1. Activate the electric parking brake.
M
2. Switch off the vehicle.
3. Secure the vehicle to prevent it from rolling
N
away, e.g. by placing wedges at the wheels on
O
the opposite side.
4. Slightly loosen the wheel bolts or wheel nuts on
P
the wheel to be changed.
Q
5. Raise the vehicle only at the specified jacking
points.
R
> Please see chapter "Jack and Lifting Plat-
S
form" on page 141.
T 6. Raise the vehicle until the wheel lifts off the
ground.
U
V
W
X
Y
Z
262
Changing wheels
Control operation of the
leveling system
Fig. 207: Screw in an assembly aid for vehicles without
PCCB
Fig. 208: Screw in two assembly aids for vehicles with PCCB
1. For vehicles without PCCB: Remove one wheel
bolt and screw in an assembly aid.
– or –
1. For vehicles with PCCB: Remove two wheel bolts
and screw in two assembly aids A and B.
NOTICE
The brake disks can become damaged if wheels are
not changed properly, especially on vehicles with
PCCB.
e When changing a wheel, screw in the assembly
aids.
2. Remove the remaining wheel bolts.
3. Remove the wheel.
4. Fit a new wheel.
5. Insert wheel bolts and tighten in diagonally op-
posite sequence.
6. Remove assembly aids and screw in remaining
wheel bolts. Initially tighten bolts only slightly in
a diagonally opposite sequence so that the wheel
is centered.
7. Inflate the tires if necessary.
8. Lower the vehicle fully and remove the jack.
9. Tighten the wheel bolts in diagonally opposite
sequence. Do not use any power tools such as
impact wrenches.
10.After changing a wheel, immediately use a tor-
que wrench to check the specified tightening
torque of the wheel bolts (118 ftlb. (160 Nm)).
11.Update the Tire Pressure Monitoring System
(TPMS) settings.
> Please see chapter "Learning the Tire Pres-
sure Monitoring System" on page 255.