Porsche Taycan Owner's Manual page 227

Fig. 185: Towing ring in front
Installing the towing ring in front
The towing hook is stored in the tool box.
> Please see chapter "Luggage Compartment" on
page 154.
1. Press the plastic cover on the lower edge of the
bumper until it juts out.
2. Pull the plastic cover out of the bumper and let it
hang by its thread.
3. Screw in the towing hook A as far as possible
counterclockwise (left-hand thread) and tighten
by hand.
Fig. 186: Towing loop in rear
Installing the towing ring in the rear
The towing hook is stored in the tool box.
> Please see chapter "Luggage Compartment" on
page 154.
1. Carefully unlatch the plastic cover on the upper
edge marketing using a suitable object.
2. Pull the plastic cover out of the bumper and stow
it safely in the vehicle.
3. Screw in the towing hook A as far as possible
counterclockwise (left-hand thread) and tighten
by hand.
Removing the towing hook
1. Screw out towing hook A clockwise (left-hand
thread).
2. Insert the plastic cover at the lower edge of the
opening.
3. Fold up the plastic cover and press at the top
until it engages in the bumper.
4. Store the towing hook in the tool box.
Using flat bed
Pulling vehicle onto flat bed
Fig. 187: Pulling vehicle onto flat bed
1. Position wooden ramps at the base of the flat
bed to reduce the angle of the pull.
2. Reel in the hoist cable and check the underside
of the vehicle for any interference.
Towing
A
B
C
D
E
F
G
H
I
J
K
L
M
N
O
P
Q
R
S
T
U
V
W
X
Y
Z
225