Porsche Taycan Owner's Manual page 204

Seat Belts
Fastening a seatbelt
A
B
C
D
E
F
G
H
I
J
K
L
M
Fig. 157: Fastening a seatbelt
N
1. Assume a comfortable seating position.
O
2. Adjust the backrest so that the shoulder belt
passes over the center of your shoulder and is
P
positioned on your upper body.
Q
3. Grasp the seatbelt by the belt latch and pull it
slowly and evenly over your chest and hip.
R
S
Information
T
The seat belt can block in the following situations:
U
– Vehicle is at an angle.
– Seat belt is pulled out abruptly.
V
– When accelerating or decelerating, when nego-
W
tiating bends or on inclines.
X
4. Insert the belt latch into the relevant seatbelt
Y
Z
202
buckle on the inner side of the seat until it locks
with an audible click.
5. Make sure that the seatbelt is not trapped or
twisted and that it is not rubbing against sharp
edges.
6. Ensure that the lap belt fits tautly across the lap.
After fastening the seatbelt, tension the lap belt
by pulling the shoulder belt up.
For pregnant women: Position the lap belt so that
it is as far down on the lap as possible and not
pressing against the abdomen.
7. During the journey, pull on the shoulder belt oc-
casionally to ensure that the lap belt remains
under tension.
Opening the belt buckle and re-
moving the seat belt
Fig. 158: Unfastening the seat belt
1. Hold the belt latch.
2. Press the red button on the seat-belt buckle.
3. Guide the belt latch up to approx. 2.75 in. (7 cm)
below the belt outlet.
On the front seats and the middle rear seat (de-
pending on equipment), the belt latch is held at
its end position by a securing knob.
On the outer rear seats, the belt latch is held in an
easily accessible position by a plastic slider (see
illustration).
4. Push plastic slider under the belt latch (see
illustration).