Porsche Taycan Owner's Manual page 198

Roof Transport System
A
B
C
D
E
F
G
H
I
J
K
L
Fig. 144: Put on the mounting protection.
M b. Attach mounting protection F onto the carrier
foot on the opposite side.
N
O
P
Q
R
S
T
U
V
W
X
Y
Fig. 145: Placing the carrier on the roof
Z
196
c. Insert long carrier A in the front and short
carrier B in the rear into vehicle receptacles K
in the openings in the roof trim while simul-
taneously adjusting them to the width of the
vehicle using the adjustable carrier legs.
Ensure that the carriers are fitted in accord-
ance with the stickers on the underside of the
carriers.
Fig. 146: Tightening the anchoring bolts
d. Screw in all four anchoring screws for the
carriers until flush using torque wrench D but
do not tighten them all the way yet.
Fig. 147: Tightening the adjusting screws
e. Tighten the adjustment screws on the upper
side of the carriers on both sides slightly but
do not tighten them all the way yet. Then
tighten the adjusting screws on the upper
side to 6 ftlb (8 Nm) with torque wrench D.
To do this, turn torque wrench D until a
"cracking noise" is heard.
Continue with installation step 4