RoboSense RS-Ruby Lite User Manual page 50

RS-Ruby Lite Users' Manual
Appendix F Suggestion of Mechanical LiDAR Mount
Please make sure that the surface of platform used for mounting LiDAR is as smooth as
possible.
Please make sure the locating pin on the mount surface do exceed 4mm high.
The material of the mount platform is suggested to be aluminum alloy in order to avoid
thermolysis effects.
When the LiDAR is installed, if there is a mounting contact surface on the upper and bottom
sides of the LiDAR, make sure that the spacing between the mounting surfaces is greater than
the height of the LiDAR to avoid squeezing the LiDAR.
Please don't mount the LiDAR in a tilt position where the tilt angle exceeds 90 degrees, this
will reduce the sensor life time.
When the LiDAR cable is routed in the mount device, please keep the cable a little slack, not
too tense.
45