Table of Contents
Advertisement
Automa�c pairing using the UI
Power up horizontal MECHA and press [1] when LEDs shows spli�ng lights
(- = - = - = -
=).
1. Connect to horizontal MECHA with MECHA SSID and password. Refer to
MECHA Controller C1 Manual
on the supplied QR code label. Record them if the label is not available.
2.
Open
192.168.8.1/config
User:
Password:
3. Select Default Mode: [AP+STA]
4. Select [Apply]
5. Power up ver�cal MECHA and press [1] when LEDs shows spli�ng lights
(- = - = - = -
=).
6. Connect to ver�cal MECHA with MECHA SSID and password.
7. Open
192.168.8.1/config
User:
Password:
8. Select Default Mode: [STA]
9. Select [Apply]
10. Select [Connect to Wi-Fi], enter SSID and password for horizontal
MECHA.
11. Connect to horizontal MECHA again using MECHA SSID.
12. Access
192.168.8.1/row
If pairing is successful, UI will show [H] at the upper le� corner and
[Team .x] near the bo�om of page, where x is the last part of the IP in
192.168.8.x. The ver�cal MECHA can be accessed by selec�ng the [H]
icon or by typing 192.168.8.x on browser address. Ver�cal MECHA UI
will show [V] at the upper le� corner and [Team] near the bo�om of
page. Select [V] to go back to horizontal MECHA. Use 2 Tabs with MECHA
IPs in browser to access both MECHAs quickly.
MECHA User's Guide v.05.4
if needed. SSID and password are printed
admin
Mecha
admin
Mecha
© 2020 FANOTEC
98
Advertisement
Table of Contents
