Set The Rotator On Configuration Page - Nodal Ninja Fanotec MECHA User Manual

Set the rotator on Configura�on page
At the top of the New page, tap the [Config] bu�on to access the
Configura�on page (192.168.8.1/config). The user and default password
are: On this page you can make special se�ngs, as we will see later. For now,
User:
Password:
enter the name of the rotator you are using: E1, E2, or P1.
Then tap the [Apply] bu�on at the bo�om of the page. This is a one-�me
se�ng, and is usually done in the factory.
Now, access the Row page by tapping the [Row] bu�on at the top of the
Configura�on page.
Tap the [info] bu�on at the top of the Row page whenever you want to find
out more details about the func�ons of the controls available on the User
Interface.
At the same �me, at the top of the page are displayed a few links to some
useful pages: a quick help page, the configura�on page and the new page:
When working with the User Interface, we can display all or only some of
the controls. To see them all, select A3 from the selec�on list next to the
[info] bu�on, which is the highest level of complexity of the interface. The
other op�ons are: S1, S2, S3, A1, and A2, where S means Simple, and A -
Advanced.
21
MECHA User's Guide v.05.4 ‒ Single Axis
admin
Mecha
© 2020 FANOTEC