The User Interface (Ui); Access The Ui With A Smartphone; Access The Ui On Your Computer - Nodal Ninja Fanotec MECHA User Manual

The User Interface (UI)

Access the UI with a smartphone

• Press the power bu�on, ⏻, for about 3 to 5 seconds to power up
MECHA, and wait un�l the spli�ng lights are displayed:
• To be able to connect your smartphone to MECHA's network, MECHA
must be in AP mode. So, at spli�ng lights, press either bu�on [1] to set
MECHA in AP mode, or bu�on [3] to set MECHA in AP+STA mode.
• Tap Se�ngs icon on your device. Under Wireless and Networks, make
sure Wi-Fi is turned on, then tap Wi-Fi. Tap the ne�work name that
contains MECHA
The default password for MECHA's network is 12345678.
• Now, MECHA's User Interface (UI) can be accessed on the smartphone's
browser at: 192.168.8.1

Access the UI on your computer

• Press the power bu�on, ⏻, for about 3 to 5 seconds to power up
MECHA, and wait un�l de spli�ng lights are displayed:
• To be able to see MECHA's UI on your PC, MECHA must be in STA mode.
So, at spli�ng lights, press either bu�on [2] to set MECHA in STA mode,
or bu�on [3] to set MECHA in AP+STA mode.
• The next step is to find the IP address which is dynamic in this case.
There are two ways to find it:
◦ 1a. Using MECHA's bu�ons, enter the code 323< to see on LEDs the
full UI address, like 192.168.2.103 (See Table of Equivalences: LEDs -
Characters),
or
◦ 1b. Usually, the IP addresses in your local network differ only by the
last number of the IP (the part displayed at the end, a�er the last
point). To display the last part of the IP, enter the code 321<. For the
example above, .103 will be displayed.
MECHA User's Guide v.05.4 ‒ Single Axis
in its name, to connect the smartphone to MECHA.
(which is a sta�c IP address).
© 2020 FANOTEC
-=-=-=-= .
-=-=-=-= .
28