Pairing Pin For More Than 2 Mechas; Temporary Pairing - Nodal Ninja Fanotec MECHA User Manual

Pairing PIN for more than 2 MECHAs

This sec�on should be read a�er you read DAC test using the UI, where we
explain how to access the user interface.
The Pairing PIN is an extra op�on you can use when the pairing method is
zLM or zLM 2, to pair automa�cally at start more than 2 MECHAs
connected to the same network or to the same hot-spot.
To set a pairing PIN number:
• Access the MECHA-H web interface, as shown in the chapter DAC test
using the UI, and go to /config page.
• Create a four-digit number - the pairing PIN - and enter this number in
the field Pairing PIN.
• Then click on [Apply] bu�on at the bo�om of the page.
All MECHA units which have the same PIN, will be paired together.
All pairing methods and requirements presented in this guide are s�ll
valid.
Once paired, if the PIN is changed in MECHA-H, it will be automa�cally set
the same in MECHA-V.
If you want to break the pairing, please set a different PIN in MECHA-V.

Temporary pairing

This type of pairing, or team, only lasts un�l the MECHA units are powered
off. To temporary pair two MECHA units:
• Power up both MECHAs.
• Start team building entering the code 1212< on horizontal MECHA. In
other words, the unit on which you enter this code, will rotate
horizontally.
• Confirm the par�cipa�on in the team, entering the code 12< on ver�cal
MECHA. This unit will rotate ver�cally.
97
MECHA User's Guide v.05.4 ‒ Dual Axis
© 2020 FANOTEC