Table of Contents
Advertisement
Pairing using MECHA's bu�ons
zLM 2 ‒ Automa�c pairing using two bu�ons
This is a zero learning method ‒ zero Learning MECHA ‒ for firmware 02057
or newer.
1. Power off both MECHA units in case they are running. To do that, hold
down the power bu�on, ⏻, for 3 to 5 seconds.
2. Power up only the horizontal MECHA (hold down the power bu�on, ⏻,
for 3 to 5 seconds). When you see the spli�ng lights (
the bu�on [1] for 3 seconds (un�l mul�ple beeps are heard). The unit
powered up first, rotates horizontally, so we name it MECHA-H.
3. Let the horizontal MECHA running then power up the other MECHA
using its power bu�on, ⏻, and when you see the spli�ng lights (
=
), press the bu�on [2] for 3 seconds (un�l mul�ple beeps are heard).
The second powered up unit rotates ver�cally, so we name it MECHA-V.
On successful pairing, MECHA-H has the middle LED on, and MECHA-V has
the two middle LEDs on, as shown in image on the previous page.
Otherwise, power down and up both MECHAs again, preferably power up
the MECHA-H first.
Next step is to test the combo using MECHA's bu�ons, and see how it works.
Once you get more familiar with MECHA, you can use it in an advanced
way, via the UI (User Interface). The zLM pairing method is only given as a
quick start, with very li�le to learn.
MECHA User's Guide v.05.4 ‒ Dual Axis
© 2020 FANOTEC
-=-=-=-=
), press
-=-=-=-
54
Advertisement
Table of Contents
