Ui Controls - Nodal Ninja Fanotec MECHA User Manual

◦ 2. Access the UI with a smartphone, as shown above (make sure
MECHA is in AP+STA mode, started by pressing [3]), then access the
Configura�on page, and scroll to the bo�om of the page. Note the
sta�c IP address (192.168.8.1), and next to it, the dynamic IP address
to access the User Interface on a computer. In our example, it is
192.168.2.103.
NOTE. If only the sta�c IP is displayed, it means that MECHA is in AP mode
and, as a result, the dynamic IP is not displayed.
Now, you can access the MECHA's User Interface (UI) on your computer's
browser by entering the IP address you found, like 192.168.2.103, in the
browser address bar.

UI Controls

In this sec�on, we will explain the func�ons of the bu�ons and the op�ons
available on the Row page, with the men�on that Ring and Turn pages are
quite similar to Row.
• Tapping the [info] bu�on, at the top of the page, will show the
descrip�ons for all the controls. At the same �me, three more bu�ons
are displayed at the top of the page - [HELP], [Config], and [NEW] - for
accessing the following pages:
◦ Help - a page with info and codes for execu�ng presets, and also for
configura�ons, or for displaying informa�on using MECHA's bu�ons.
◦ Configura�on page - user: admin, and default password: Mecha.
◦ What's new? - a page where you can find informa�on about the
current firmware version and the versions published so far.
29
MECHA User's Guide v.05.4 ‒ Single Axis
© 2020 FANOTEC