Table of Contents
Advertisement
Other pairing methods
zLM ‒ Automa�c pairing using bu�ons
This is a zero learning method ‒ zero Learning MECHA ‒ for firmware 02011
or newer.
As you already know, we communicate with MECHA through a web inter-
face, or using its own bu�ons, especially to enter some codes. We use the
power bu�on, ⏻, to enter 0 (zero) into the MECHA unit. Therefore, a code
that starts with zero, we call it a power code.
In the zLM method of pairing, the first step is to create a code ‒ a power
code, and the second, to use this code to pair the MECHA units.
Step 1
Create an 8-digit code followed by the greater-than sign, as follows:
• the first digit must be 0 (zero)
• the next sequence of seven digits must be a combina�on of the
digits 1, 2, and 3, so that two iden�cal digits are not in
consecu�ve posi�ons
• add the greater-than sign (>) at the end
Example:
0
1
2
Please do not use this code, because you will also use it as a pass-
word.
When the
MECHA units connect automa�cally and become a Dual Axis
Combo (DAC).
95
MECHA User's Guide v.05.4 ‒ Dual Axis
3
1
2
3
1
power code
is entered in both MECHAs, these two
© 2020 FANOTEC
>
Advertisement
Table of Contents
