Connecting Additional Equipment - Dantherm HCC 2 Alu Service Manual

Connecting additional equipment

Access to
The integrated controller has various options to connect additional external equipment. To
connections
gain access to the controller, please remove the top cover of the unit
WARNING - always disconnect the power by removing the 230V plug from the socket, before
opening the unit !
Remove the 10 piece TX20 screws, and remove the front. Please be careful to avoid the cover
to fall down on the floor, or possible injuring any persons.
External
This illustration shows the various connections:
connections options
Connection Description
1: ETHERNET LAN connection for connecting to wireless router for BMS .
2: MODBUS
3: ANTENNA Wireless connection point for proprietary remote control.
4: DIGI IN
2
1
Modbus connection for hardware accessory modul (HAC)
External digital input, to select specific operations. Parameters can be set in
the PC-tool.
Fig. 22
3 4
Fig. 23
23