Installation - Dantherm HCC 2 Alu Service Manual

Installation

Introduction
The HCC 2 Alu must fulfill all of the previous consideration prior to starting any installation
process.
HCC 2 Alu is delivered in a cardboard box. Please check packaging for damages before un-
Wrapping
packing.
Multi purpose The enclosed bracket can and should be used, both for wall and for ceiling installation. The
mounting bracket bracket will automatically tilt the unit 1° towards the condensate drain, when mounted un-
derneath the ceiling.
Wall mounting Please follow this procedure to install the HCC2 Alu vertical onto a wall.
Step Action
1
2
3
4
5
6
Fig. 12
Drill two holes for the
bracket, fulfilling all dimen-
sion requirements shown on
page 38
Mount the bracket with ap-
propriate screws
Lift the unit onto the bracket
Drill and mount two appro-
priate screws in the lower
unit bracket
Connect ducts according il-
lustration at page 10
IMPORTANT: the T1 and T4
outside air ducts, must AL-
WAYS be routed to the duct
connections in the bottom
Connect drainage hose. See
more at page 16.
Illustration
1 2
1 4
Fig. 13
1 1
13