Mitsubishi Q Series User Manual page 68

3 SPECIFICATIONS
Setting mode
11)
8)
Normal control mode
9)
Setting mode
12)
Normal control mode
15)
3 - 37
(c) Between control modes ((8) to (15) of the chart)
The mode is switched by setting a value to the control mode (buffer
memory address: 50, 82) at the operation mode (Xn1: ON).
After the completion of the switching, the value of the control mode
switched to the control mode (buffer memory address: 30) is stored.
Program control mode
Manual control mode 1
Manual control mode 2
14)
Program control mode
13)
Manual control mode 1
Manual control mode 2
*2: The control status at switching differs depending on the intelligent function
module switch setting. (Refer to (3) in this section)
(2) Control status
The Q62HLC has the output signals (Y), buffer memory and intelligent function
module switch which set its control status.
The control status of the Q62HLC is as indicated below.
(a) Intelligent function module switch setting
Output setting for CPU stop error (refer to Section 4.5)
Intelligent function module switch setting
If a CPU stop error occurs at the setting of "CLEAR"
Other than above
(b) Unused channel setting
Unused channel setting (refer to Section 3.5.32)
Buffer memory address (Decimal) 61, 93
Unused
Used
Control mode Buffer memory address
No.
10)
8)
9)
10)
11)
Control mode Buffer memory address
No.
12)
13)
14)
15)
MELSEC-Q
(Decimal) 50, 82
1
3
*2
2
0
(Decimal) 50, 82
*2
2
1
3
0
Control status
Temperature
PID control
judgment
— —
In accordance with control
status of other setting items
: Executed, —: Not executed
Control status
Temperature
PID control
judgment
— —
In accordance with control
status of other setting items
: Executed, —: Not executed
Alert
judgment
—
Alert
judgment
—
3 - 37