Mitsubishi Q Series Connectivity Manual
Supports qj71e71 / qj71e71-b2 / qj71e71-b5 / qj71e71-100 series module
Hide thumbs
Also See for Q Series:
- User manual (244 pages) ,
- Programming manual (194 pages) ,
- User manual (74 pages)
Advertisement
Quick Links
Series HMI Connection Manual
Mitsubishi Q Series Ethernet
（Supports QJ71E71 / QJ71E71-B2 / QJ71E71-B5 / QJ71E71-100 Series Module）
HMI Factory Setting:
Baud rate: 192.168.0.1
Controller Station Number: 1025
Control Area / Status Area: D0 / D10
Connection
Standard jumper Cable/ Network Cable without jumper (Auto-detected by HMI)
Definition of PLC Read/Write Address
a. Registers
Type
Input
Output
Internal Relay
Special Internal Relay
Link Relay
Annunciator
Timer Value
Counter Value
Data Register
Special Data Register
Link Register
b. Contacts
Type
Input
134
Format
Read/Write Range
Word No. (n)
Xn
X0 – X1FF0
Yn
Y0 – Y1FF0
Mn
M0 – M8176
Mn
M9000 – M9240
Bn
B0 – B1FF0
Fn
F0 – F2032
TNn
TN0 – TN2047
CNn
CN0 – CN2047
Dn
D0 – D8191
Dn
D9000 – D9255
Wn
W0 – W1FFF
Format
Bit No. (b)
Xb
X0 – X1FFF
Data Length
Word
Word
Word
Word
Word
Word
Word
Word
Word
Word
Word
Read/Write Range
V1.01 Revision November, 2011
Note
Hexadecimal,
2
Hexadecimal,
2
2
3
Hexadecimal,
2
2
Hexadecimal
Note
Hexadecimal
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for Mitsubishi Q Series
Summary of Contents for Mitsubishi Q Series
- Page 1 Series HMI Connection Manual Mitsubishi Q Series Ethernet （Supports QJ71E71 / QJ71E71-B2 / QJ71E71-B5 / QJ71E71-100 Series Module） HMI Factory Setting: Baud rate: 192.168.0.1 Controller Station Number: 1025 Control Area / Status Area: D0 / D10 Connection Standard jumper Cable/ Network Cable without jumper (Auto-detected by HMI) Definition of PLC Read/Write Address a.
- Page 2 Before using this communication protocol, the user needs to set communication module via GX Developer programming tools. For more detailed information regarding the setting method, please refers to Mitsubishi PLC User Manual. The device address must be the multiple of 16.
- Page 3 Series HMI Connection Manual Settings Screen Editor 1. HMI Configuration Setting V1.01 Revision November, 2011...
- Page 4 Series HMI Connection Manual 2. PLC Configuration Setting GX Developer (V8.35M) 1. Network Parameter MNET/10H Ethernet Settings Item Setting Network Type Ethernet Starting I/O No. 0000 Network No. Group No. Station No. Mode On-line V1.01 Revision November, 2011...
- Page 5 Open Method Unpassive Fixed buffer Send Fixed buffer communication procedure Procedure exist Existence confirmation No confirm Host Station Port No. 0401(HEX) 4. For more detailed information regarding the setting method, please refers to Mitsubishi PLC User Manual. V1.01 Revision November, 2011...
Need help?
Do you have a question about the Q Series and is the answer not in the manual?
Questions and answers