Mitsubishi Q Series User Manual page 27

2 SYSTEM CONFIGURATION
Applicable CPU module
CPU type
C Controller module
QJ72LP25-25
QJ72LP25G
QJ72LP25GE
QJ72BR15
(2) Support of the multiple CPU system
(3) Compatibility with online module change
2 - 2
CPU model
Q06CCPU-V
Q06CCPU-V-B
*1 Limited within the range of I/O points for the CPU module.
*2 Can be installed to any I/O slot of a base unit.
(b) Mounting to a MELSECNET/H remote I/O station
The table below shows the network modules and base units applicable to
the Q62HLC and quantities for each network module model.
Depending on the combination with other modules or the number of
mounted modules, power supply capacity may be insufficient.
Pay attention to the power supply capacity before mounting modules, and if
the power supply capacity is insufficient, change the combination of the
modules.
Applicable network
No. of modules
module
Up to 64
*1 Limited within the range of I/O points for the network module.
*2 Can be installed to any I/O slot of a base unit.
Remark
The Basic model QCPU or C Controller module cannot create the MELSECNET/H
remote I/O network.
When using the Q62HLC in a multiple CPU system, refer to the following manual
first.
• QCPU User's Manual (Multiple CPU System)
(a) Intelligent function module parameters
Write intelligent function module parameters to only the control CPU of the
Q62HLC.
Q62HLC is compatible with online module change.
*1
No. of modules
Main base unit
Up to 64
*1
Main base unit of
remote I/O station
MELSEC-Q
*2
Base unit
Extension base unit
Applicable N/A
*2
Base unit
Extension base unit of
remote I/O station
Applicable N/A
2 - 2
2