Un\G320 To Un\G500, Un\G576 To Un\G756) - Mitsubishi Q Series User Manual

3 SPECIFICATIONS
3.5.64 Program pattern (buffer memory address 320 to 500, 576 to 756: Un\G320 to
Un\G500, Un\G576 to Un\G756)
Set value
Execution pattern monitor
(Buffer memory address: 264, 520)
3 - 91
This setting sets the program pattern to be used for the program control function.
For the program pattern, there are 3 patterns of program pattern 1 to 3, and each
program pattern sets the following 8 items.
For the buffer memory address for each item, refer to Section 3.5.1.
For details of the program control function, refer to Section 3.2.12.
This setting is available only in the setting mode.
For confirming the change, it is needed to turn on the setting change command
(YnB).
(1) Program pattern final setting
(a) This setting specifies the final segment to complete the program pattern.
At link setting, each program pattern execution will complete at the final
segment.
(b) The default value is 16.
The setting range is 1 to 16.
(2) Program pattern link setting
(a) The Q62HLC can link program patterns and make a setting of program
pattern up to 48 segments. (One program pattern consists of 16 segments.)
The pattern link specifies the program pattern of the link destination.
(b) When the program pattern has been linked, the program pattern of the link
destination is executed in sequential order starting from segment 1. The link
destination program pattern of the segment 1 set value starts from the set
value at the pattern end of the link source.*
is not performed.
*1: The same operation as the PV starting 1 of Section 3.5.61 "Start mode"
Example: When specifying the program pattern 2 with the pattern link of the
program pattern
(SV)
Program Pattern 1
Set value of
pattern end
Linking part
1
MELSEC-Q
1
The pattern end output of the link
Program Pattern 2
Time 1
2
Time
3 - 91