Backing Up The Di Driver System Software Image - National Instruments NI DIDS-2103 User Manual

3.2.4 Backing Up the DI Driver System Software Image

A DI Driver System software backup image can be created by following the instructions below. It is recommended
this procedure be performed after the system has been calibrated and ready for deployment.
*Note: The DI Driver System must be in static IP address mode for the backup to restore correctly. For more
information on changing your system to static IP mode see
Changing The Network Settings Of The DI Driver
System.
1. Open the SCM console and select Backup Target from the File menu to open the Real-Time System Backup
dialog.
2. Select the the desired system from the Target dropdown menu.
3. Enter the User Name and Password for that particular system. The factory default User Name is admin and the
default Password is blank. Users may enter an Encryption Passphrase if desired, but it is not necessary to enter
one. If an Encryption Passphrase is entered, it will be stored in the backup file and will be needed when installing
the backup file onto the controller again.
4. In the lower left corner Real-Time Backup and Restore dialog, press the Backup Target button to browse the
PC to specify the location to save the DI Driver System software image zip file. Select OK to close the location
selection dialog.
NI DIDS-2100 Series User Manual | © National Instruments | 35