National Instruments NI DIDS-2103 User Manual page 106

Timing Ch1
Tip Strip: Start Of Injection angle with respect to TDC
Units: DBTDC
Detail: Specifies the Start of Injection (SOI) timing in Degrees before TDC.
Delay Ch1
Tip Strip: Delay between timing and actual Start of Injection (SOI) angle.
Detail: Specifes the time-based delay between the
primarily exists for use when using the PFI channel as a digital output channel. For alternative PFI channel
output configurations, click the PFI Output Config button.
Duration Ch1 (msec)
Tip Strip: Duration of injection pulse
Units: msec
Detail: Time duration of the EPT mode injection pulse. The ON/OFF button above each
parameter determines whether the pulse will be active or inactive.
Duration Ch1 (CAD)
Tip Strip: Duration of injection pulse
Units: CAD
Detail: This parameter is always disabled but automatically updated with a calculated crank angle degrees
duration value. It is calculated based on
Engine Position Tracking
Timing Ch2-4 (DBTDC), Delay Ch2-4 (msec), Duration Ch2-4 (msec) and (CAD)
Tip Strip: Timing, Delay and Duration of injection pulse
Units: DBTDC, msec and CAD
Detail: See information for
106 | ni.com | NI DIDS-2100 Series User Manual
Duration
Setup window.
Duration Ch1 (msec)
Timing and the Start of Injection angle. The feature
(msec) and engine speed
and Duration Ch1 (CAD)
Timing and
shown in the EPT Tab of the
Duration