Table1D_X_FlexControlParameters
Tip Strip: Selects destination of the 1D lookup table output
Detail: Array of Flex Control Parameter selectors. Each selector maps the lookup table output to a Flex
Control Parameter. The selected parameter will be overwritten by the lookup table output. The Flex Control
Parameter can be selected one of two ways: by left unclicking and searching through the full list of Flex
Control Parameters, shown above, or by right unclicking and searching through a hierarchical list of menus
to find the particular Flex Control Parameter of interest, as shown in the
Direct Mapping
Section.
NI DIDS-2100 Series User Manual | © National Instruments | 149