National Instruments NI DIDS-2103 User Manual page 147

A 1D lookup table control consists of a set of matching X and Y arrays. The X values correspond to the input
parameter as specified in Table1D_X_InputSelector. The 1D lookup table output is routed to the Flex Control
Parameters selected in Table1D_X_FlexControlParameters. The Flex Control Parameters are a list of many controls
from the various setup windows of the DI Driver System. When a Flex Control Parameter is selected here, the value
from the lookup table output will overwrite that parameter. The table is only active when it is enabled via
Table1D_X button.
Enable Table1D_X
Tip Strip: Enables 1D Table
Detail: When ON the lookup table is enabled and the selected Flex Control Parameters will be overwritten by
the lookup table output.
4.9.1 Table1D
NI DIDS-2100 Series User Manual | © National Instruments | 147
Enable