Installing The Aileron Servos - Seagull Models SHOCK-CUB 35-55cc Assembly Manual

2.
Epoxy
3.

INSTALLING THE AILERON SERVOS

1.
2.
Flap control horn
Minimum servo spec.
Torque : 122 oz-in (8.8 kg-cm) @ 6.0V;
139 oz-in (10.0 kg-cm) @ 7.4V
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Place the servo between the mounting
blocks and space it from the hatch. Use a
pencil to mark the mounting hole loca-
tions on the blocks.
3.
Use drill bit in a pin vise to drill the
mouting holes in the blocks.
4.
Apply 2-3 drops of thin C/A to each
of the mounting holes. Allow the C/A to
cure without using accelerator.
7