INSTALLING THE FUSELAGE SERVOS
Because the size of servos differ, you
may need to adjust the size of the precut
opening in the mount. The notch in the
sides of the mount allow the servo lead to
pass through.
Install the rubber grommets and brass
collets into all servos. Test fit the servos
into the fuselage servo mounts.
Secure the servos with the screws pro-
vided with your radio system.
1.
Elevator servo
Elevator servo
2.
Elevator servo arm
Rudder servo arm
Elevator servo arm
INSTALLING THE RECEIVER SWITCH
Install the switch into the precut hole in
the side, in the fuselage.
.
Throttle servo
Rudder servo
Throttle servo arm
1.
.
2.
3.
INSTALLING THE ENGINE SWITCH
1.
3/32" Hole
Trim and cut
.
Switch
Trim and cut
11