2.
HINGING THE ELEVATORS
Glue the elevator hinges in place using
the same techniques used to hinge the ai-
lerons.
1.
INSTALL ELEVATOR CONTROL HORN
1.
Fiberglass control horn
2.
3.
1.
2.
Epoxy
ELEVATOR AND STABILIZER
INSTALLATION
With the stabilizer held firmly in place,
use a pen and draw lines onto the stabi-
lizer where it and the fuselage sides meet.
Do this on both the right and left sides
and top and bottom of the stabilizer.
Remove the stabilizer. Using the lines
you just drew as a guide, carefully remove
the covering from between them using a
modeling knife.
25