Installing The Stopper Assembly; Fuel Tank Installation - Seagull Models SHOCK-CUB 35-55cc Assembly Manual

SHOCK CUB 35-55cc
32.
Collar
33.
34.
INSTALLING THE STOPPER
Using a modeling knife, carefully cut
off the rear portion of one of the 3 nylon
tubes leaving 1/2" protruding from the
rear of the stopper. This will be the fuel
pick up tube.
Using a modeling knife, cut one length
of silicon fuel line. Connect one end of
the line to the weighted fuel pick up and
the other end to the nylon pick up tube.
16
ASSEMBLY
Instruction Manual.
1.
Carefully bend the second nylon tube up at
a 45º angle. This tube is the vent tube.
Test fit the stopper assembly into the tank.
It may be necessary to remove some of the
flashing around the tank opening using a
modeling knife. If flashing is present, make
sure none falls into the tank.
With the stopper assembly in place, the
weighted pick-up should rest away from the
rear of the tank and move freely inside the
tank. The top of the vent tube should rest just
below the top of the tank. It should not touch
the top of the tank.
When satisfied with the alignment of the
stopper assembly tighten the 3 x 20mm ma-
chine screw until the rubber stopper expands
and seals the tank opening. Do not over-
tighten the assembly as this could cause the
tank to split.
.

FUEL TANK INSTALLATION

1.