Specifying A System Ip Address - 3Com 3CRWX120695A Installation And Basic Configuration Manual

WX1200# set system countrycode US
success: change accepted.
WX1200# display system
===============================================================================
Product Name:
System Name:
System Countrycode: US
System Location:
System Contact:
System Description: WX1200
System IP:
System MAC:
===============================================================================
Boot Time:
Uptime:
===============================================================================
Fan status:
Temperature: temp1 ok
PSU Status:
Memory:
Total Power Over Ethernet : 32.000
===============================================================================
Specifying a System
IP Address
WX1200
WX1200
0.0.0.0
00:0B:0E:02:76:F6
2003-05-07 08:28:39
0 days 04:00:07
fan1 OK fan2 OK fan3 OK
temp2 ok
Lower Power Supply DC ok AC ok
115.09/496.04 (23%)
You can designate one of the IP addresses configured on a WX switch's
VLAN to be the system IP address of the switch. The system IP address
provides a common IP interface and source IP address for some 3Com
management and Mobility Domain operations. The system IP address is
required by some features, including roaming. The system IP address is
also used by default for other features, including RADIUS and the system
log.
To assign one of the configured IP addresses to be the system IP address,
use the following command:
set system ip-address ip-addr
Enter an IP address in dotted decimal notation. This command sets the IP
address you specify to be the system IP address.
To verify the configuration change, use the following command:
display system
temp3 ok
Upper Power Supply missing

Specifying a System IP Address

59