Configuring For Authenticating Users - 3Com 3CRWX120695A Installation And Basic Configuration Manual

60 C 3: C
HAPTER ONFIGURING A
WX1200# set system ip-address 10.10.10.4
success: change accepted.
WX1200# display system
===============================================================================
Product Name:
System Name:
System Countrycode:
System Location:
System Contact:
System Description: WX1200
System IP:
System MAC:
===============================================================================
Boot Time:
Uptime:
===============================================================================
Fan status:
Temperature: temp1 ok
PSU Status:
Memory:
Total Power Over Ethernet : 32.000
===============================================================================
Configuring for
Authenticating
Users
WX S
WITCH FOR
The following commands configure the system IP address to be
10.10.10.4, the IP address on VLAN mgmt, and verify the change:
WX1200
WX1200
10.10.10.4
00:0B:0E:02:76:F6
2003-05-07 08:28:39
0 days 04:00:07
fan1 OK fan2 OK fan3 OK
temp2 ok
Lower Power Supply DC ok AC ok
115.09/496.04 (23%)
A WX switch can provide authentication, authorization, and accounting
(AAA) services for wireless and wired users. Wireless users are attached to
a WX switch through a MAP access point. Wired users are attached to a
WX switch through wired authentication ports.
By default, all a WX switch's ports are set as wired network ports. Wired
network ports connect the switch to other networking devices such as
switches and routers.
To provide authentication to a wired user, you must set that user's port
to be a wired authentication port.
To provide authentication to wireless users, you must configure the
WX to support a MAP. How you configure the WX will depend on
how the MAP is connected to the WX. There are two categories of
MAP to WX connection: directly connected and distributed.
B S
ASIC ERVICE
temp3 ok
Upper Power Supply missing