3Com 3CRWX120695A Installation And Basic Configuration Manual page 74

74 C 3: C WX S B S
HAPTER ONFIGURING A WITCH FOR ASIC ERVICE
set {ap port-list | dap dap-num} radio {1 | 2}
| |
antennatype {ANT1060 ANT1120 ANT1180}
To enable or disable RF Auto-Tuning for channel or power assignment,
use the following commands:
set radio-profile name auto-tune channel-config
{enable | disable}
set radio-profile name auto-tune power-config
{enable | disable}
Applying a Radio Profile to Radios and Enabling the Radios
To apply a radio profile to radios, use the following command:
set {ap port-list | dap dap-num} radio {1 | 2} radio-profile
name mode {enable | disable}
The following commands applies radio profile rp1 to radio 1 on MAP
access ports 1, 2, and 4 and on Distributed MAP 1 and Distributed MAP 2
and enables the radios:
WX1200# set ap 1,2,4 radio 1 radio-profile rp1 mode enable
success: change accepted.
WX1200# set dap 1,2 radio 1 radio-profile rp1 mode enable
success: change accepted.
The following command applies radio profile rp1 to radio 2 on MAP
access ports 1, 2, and 4 and on Distributed MAP 1 and enables the
radios:
WX1200# set ap 1,2,4 radio 2 radio-profile rp1 mode enable
success: change accepted.
WX1200# set dap 1 radio 2 radio-profile rp1 mode enable
success: change accepted.
Displaying Radio Configuration Information
To verify radio configuration changes, use the following commands:
display ap config [port-list [radio {1 | 2}]]
display dap config [dap-num [radio {1 | 2}]]