3Com 3CRWX120695A Installation And Basic Configuration Manual page 43

WX1200# display vlan config
VLAN Name
---- ---------------- ------ ----- ----- ---------------- ----- -----
1 default
2 mgmt
3 red
4 blue
The vlan-id parameter can be the VLAN number or the VLAN name.
To verify the changes, use the following commands:
display vlan config
display interface
The following commands configure a VLAN named mgmt and two
additional VLANs over an 802.1Q trunk link for network traffic:
WX1200# set vlan 2 name mgmt
success: change accepted.
WX1200# set vlan mgmt port 5
success: change accepted.
WX1200# set vlan 3 name red
success: change accepted.
WX1200# set vlan red port 5 tag 30
success: change accepted.
WX1200# set vlan 4 name blue
success: change accepted.
WX1200# set vlan blue port 5 tag 20
success: change accepted.
To avoid confusion, do not assign numbers as VLAN names. Every VLAN
on a WX switch has both a VLAN name used for authorization purposes
and a VLAN number. VLAN numbers can vary uniquely for each WX
switch and are not related to 802.1Q tag values even when used. VLAN
names must be unique among all WX switches in a Mobility Domain.
The following command displays VLAN information:
Admin VLAN Tunl
Status State Affin Port
Up Down
Up Down
Up Down
Up Down
Configuring IP Connectivity
5
5
5
5
5
5
5
Port
Tag State
none Up
30 Up
20 Up
43