FTS-3 Fetal Telemetry System Service Manual
No.
Connect to
1
Indicative Light Board
10.5.3 Replacing the Fan
To remove the fan,
1) Separate the upper assembly and the lower assembly.
2) Unplug the fan wires connector from the power cable bundle.
3) Remove the two screws securing the fan frame.
4) Remove the three screws and sponge.
To install the fan,
Install the fan in a reverse procedure. Ensure the wires' connector is correctly connected to
connector on the power cable bundle.
Figure 10- 15
Figure 10- 16
- 37 -
Disassembling FTS-3
1