Chapter 2 Overview; Introduction; General Information; Safety Precautions - EDAN FTS-3 Service Manual

FTS-3 Fetal Telemetry System Service Manual

Chapter 2 Overview

NOTE:
This service manual is written to cover the maximum configuration. Therefore, your
model may not have some of the parameters/modules described, depending on what you
have ordered.

2.1 Introduction

FTS-3 fetal telemetry system can be used with F6 or F9 series fetal/maternal monitor. This
service manual is a reference for periodic preventive maintenance and corrective service
procedures for FTS-3.
It provides troubleshooting information, assembly procedures, instructions for functional testing
and performance verification. It is intended for use only by technically qualified service
personnel.
When performing a service procedure, follow the instructions exactly as presented in this manual.
Failure to do so might damage FTS-3, invalidate the product warranty or lead to serious personal
injury.

2.2 General Information

 FTS-3 fetal telemetry system (hereinafter called FTS-3) is designed to comply with the
international safety requirements IEC/EN 60601-1 for medical electrical equipment. It is
class I equipment.
 The protective degree against electric shock of the patient connections is:
Ultrasound (FHR1, FHR2)
External TOCO
DECG, MHR(form MECG)
 FTS-3 described in this manual is not protected against:
a) The effects of high frequency currents
b) The interference of electrosurgery equipment

2.3 Safety Precautions

WARNING and CAUTION messages must be observed. To avoid the possibility of injury,
observe the following precautions during the maintaining the instrument.
WARNING
Type BF
Type CF
- 4 -
Installation