Electrical Requirements; Safety Requirements; Installing Fts-3; Installing The Base Station On A Flat Surface - EDAN FTS-3 Service Manual

FTS-3 Fetal Telemetry System Service Manual
anesthetics or other materials may occur.
3. Keep the environment clean. Avoid vibration. Keep it far from corrosive medicine, dust
area, high-temperature and humid environment.

3.2 Electrical Requirements

Operating Voltage:
Operating Frequency:
Maximum Input Current:
Battery:

3.3 Safety Requirements

 SHOCK HAZARD- The power receptacle must be a three-wire grounded outlet. A
hospital grade outlet is required. Never adapt the three-prong plug from the base station
to fit a two-slot outlet. If the outlet has only two slots, make sure that it is replaced with
a three-slot grounded outlet before attempting to operate the base station.
 Do not touch signal input or output connector and the patient simultaneously.
 Equipment and devices that connect to FTS-3 should form an equipotential body to
ensure effective grounding.
 Do not switch on the base station until all cables have been properly connected and
verified.

3.4 Installing FTS-3

3.4.1 Installing the Base Station on a Flat Surface

Place FTS-3 on a flat surface. Make sure the surface does not vibrate, and is free of corrosive
medicine and dust. Keep it distant from the metal or shielded material and devices with strong
radiation. Please donot place it in the shielded room. Keep a distance of at least 1.5m from the
device of the same type.

3.4.2 Mounting the Base Station on a Wall

1.
FTS-3 should only be mounted on a solid concrete or brick wall.
2.
Make sure the wall mounting board is firmly fixed to the wall. If there is any doubt, do not hang
FTS-3 to this board.
3.
Make sure the base station is safely hung on the posts of the board before releasing your hands
from the base station.
100V-240V~
50Hz/60Hz
﹤0.8A
14.8VDC/5000mAh
WARNING
- 9 -
Installation