Electrical Requirements; Safety Requirements; Installing The Monitor; Installing The Monitor On A Flat Surface - EDAN F9 Service Manual

F9 Fetal & maternal Monitor Service Manual

3.2 Electrical Requirements

Operating Voltage:
Operating Frequency:
Input Power:

3.3 Safety Requirements

SHOCK HAZARD- the power receptacle must be a three-wire grounded outlet. A
hospital grade outlet is required. Never adapt the three-prong plug from the monitor to
fit a two-slot outlet. If the outlet has only two slots, make sure that it is replaced with a
three-slot grounded outlet before attempting to operate the monitor.
Do not touch signal input or output connector and the patient simultaneously.
Equipment and devices that connect to the monitor should form an equipotential body to
ensure effective grounding.
Do not switch on the monitor until all cables have been properly connected and verified.

3.4 Installing the Monitor

3.4.1 Installing the Monitor on a Flat Surface.

Place the monitor on a flat surface. Make sure the surface does not vibrate, and is free of
corrosive medicine and dust.
100V-240V ~
50Hz/60Hz
110VA
Figure 3-1 The monitor on a flat surface
- 8 -
Installation