Epson RC620 Safety And Installation page 104

3. First Step
Start Mode: Auto
Auto mode displays the Operator Window. The Operator Window is configured
according to the settings in Project | Properties.
The current controller Control Device sets the mode of Auto operation.
Control Device
Self
Remote I/O
Auto Start
You can configure EPSON RC+ 6.0 to automatically start when Windows starts.
From the Setup | System Configuration | Auto Start page, set the Start EPSON
RC+ 6.0 after Windows start check box.
In addition, if you set the checkbox above, you can specify EPSON RC+ 6.0
command line options (/auto, /nosplash, etc.) in the Command line options text
box. Refer to the EPSON RC+ 6.0 Users Guide: 4.2.10 Command Line Options.
You can also specify if the main function should automatically be started after a
delay.
startup.
When using auto start, ensure that your application can automatically start safely
NOTE
and inform operators how to abort the startup.
92
Description
The Operator Window can be used as a simple operator
interface for production.
The Operator window is displayed with no operator buttons
to allow any diagnostic messages to be viewed.
During the delay, the operator can click Stop to abort the automatic
RC620 Safety and Installation Rev.8