Table of Contents
Advertisement
Figure 71
1. Reserve tank-cap
2. Reserve tank
5.
Disconnect the lower radiator hose and allow
the coolant to flow into a drain pan.
Note:
When the coolant stops flowing, connect
the lower radiator hose.
6.
Slowly fill the radiator with a 50/50 mixture of
water and permanent ethylene-glycol antifreeze
7.
Top off the radiator and install the cap
70).
8.
Slowly fill the coolant-reserve tank until level
reaches the bottom of the filler neck
9.
Install the reserve-tank cap
10.
Start the engine and operate it until it is warm.
11.
Shut off the engine, check the coolant level, and
replenish the coolant, if necessary.
g026143
(Figure
(Figure
71).
(Figure
71).
54
Brake Maintenance
Checking the Brake-Fluid
Level
Service Interval: Before each use or daily—Check
the brake-fluid level. (Check the
level before the engine is first
started and daily thereafter.)
Every 1,000 hours/Every 2 years (whichever
comes first)—Change the brake fluid.
Brake-fluid type: DOT 3 brake fluid
Note:
The brake-fluid reservoir ships from the factory
filled with DOT 3 brake fluid.
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Remove the hood.
5.
Check the fluid level in the brake-fluid reservoir
(Figure 72
and
Figure
Note:
The fluid level should be up to the Full
line on the reservoir.
Figure 72
1. Brake-fluid reservoir
73).
g009817
Advertisement
Table of Contents
