PSU Assembly Replacement
Tools Required
•
Torque screwdriver, TORX T10
•
Torque screwdriver, TORX T20
Removal Procedure
Refer to
Step 1. Remove the 3/4 rack module top as described in
page
Step 2. Remove the PSU Deck Assembly as described in
page
Step 3. Uncross the insulator (item 1) with the PSU Assembly.
Step 4. Disconnect the secondary cable (item 2) from the PSU Assembly.
NOTE
Be careful not to break the hook of connector.
Step 5. Remove the four TORX T10 screws (item 3) fastening the PSU Deck.
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
Chapter 6
Figure 6-5
and for this procedure.
92.
95.
Replacement Procedure
PSU Assembly Replacement
"3/4 Rack Module Top Replacement" on
"PSU Deck Assembly Removale" on
97