Front Panel Assembly Removal
Tools Required
•
Torque screwdriver, TORX T20
•
Box torque wrench, 5/8 inch
Removal Procedure
Refer to
Figure 6-7
and for this procedure.
Step 1. Remove the 3/4 rack module top as described in
page
92.
Step 2. Remove the PSU Deck Assembly as described in
page
95.
Step 3. Remove the Front Chassis Assembly as described in
on page
99.
Step 4. Release the cable from the cable clamp (item 1).
Step 5. Remove the five 5/8 inch nuts and washers (item 2) fastening the BNC connector.
Step 6. Remove the A34 Analog Board from Front Panel.
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
Chapter 6
Replacement Procedure
Front Panel Assembly Removal
"3/4 Rack Module Top Replacement" on
"PSU Deck Assembly Removale" on
"Front Chassis Assembly Removal"
101