Front Chassis Assembly Removal
Tools Required
•
Torque screwdriver, TORX T20
Removal Procedure
Refer to
Figure 6-6
and for this procedure.
Step 1. Remove the 3/4 rack module top as described in
page
92.
Step 2. Remove the PSU Deck Assembly as described in
page
95.
Step 3. Disconnect the two cables (item 1) from the A34 Analog Board.
Step 4. Disconnect the USB cable (item 2) from the Interface Board.
Step 5. Remove the three TORX T20 screws (item 3) fastening the Front Chassis Assembly.
Replacement Procedure
Step 1. Reverse the order of the removal procedure.
Chapter 6
Replacement Procedure
Front Chassis Assembly Removal
"3/4 Rack Module Top Replacement" on
"PSU Deck Assembly Removale" on
99